RPT_ET1616 - T-connector joint diameter 16mm

Technical characteristics

• Type: connection fitting
• Brand: PREVOST
• Diameter: 16mm

Instructions for use

To use this tool correctly, it is strongly recommended to follow the steps below:

1. Pipe preparation: Make sure you have pipes compatible with an outer diameter of 16mm. Cut the pipes to the desired length using an appropriate cutting tool.
2. T-fitting preparation: Check that the T-fitting is clean and in good condition. Ensure that the ends of the fitting and the T openings are free of any debris or obstructions.
3. Insert the pipes: Insert each end of the pipes into the openings of the T-fitting. Make sure they fit firmly and securely. If necessary, use a lubricant to facilitate insertion.
4. Alignment check: Ensure that the pipes are properly aligned in the T-fitting. Visually check and make sure there is no deformation or abnormal angle.
5. Securing the pipes: If necessary, use clamps or other appropriate fastening devices to hold the pipes firmly in place where they connect to the T-fitting.
6. Leak test: Once the pipes are secured, check for leaks at the connections. Open the corresponding water or fluid supply system and carefully observe the connections for any leaks. If a leak is detected, tighten the connections or replace the sealing gaskets if necessary.

Do not hesitate to contact us for more information.

Non-contractual photo

See all reviews.