To be improved

Restagraf – Strap with Anchor 140 × 5 mm

Clamping strap with integrated anchor for quick and clean fastening of bundles, hoses, and sleeves on bodywork/chassis. Ideal for the workshop: clip, tighten, cut → it's installed.

Key Features

• Integrated anchor: the lug clips into a hole for immediate holding without a collar or screws.
• Quick & clean installation: cable pass + notched tab, flush cut.
• Technical polyamide: resistant to vibrations, workshop oils/fluids, and weather conditions.
• Width 5 mm: good balance of hold/compactness for most vehicle bundles.

Technical Specifications

• Dimensions: length 140 mm · width 5 mm (usable up to ~Ø 30–35 mm depending on tightening).
• Material: black polyamide/nylon (PA), automotive use.
• Anchor: expandable lug for standard bodywork holes (indicative Ø 6–7 mm).
• Thermal range (indicative): approximately −40 to +85 °C (good workshop practice).
• Mechanical resistance: suitable for holding bundles and small components (do not use as a lifting strap).

Recommended Applications

• Fastening of electrical bundles, hoses, washer fluid pipes, sensors, antenna lines.
• Guiding/securing on wheel arches, bulkheads, side members, plastic/metal supports.
• Restoration after bodywork/mechanical intervention (neatly re-staple the harnesses).

Installation Tips

1. Identify a compatible hole (Ø 6–7 mm). If necessary, drill and deburr.
2. Clip the anchor until it locks (noticeable slowdown).
3. Wrap the strap around the bundle and tighten without crushing the sleeves.
4. Cut the excess length flush to avoid any sharp edges.

Best Practices & Safety

• Avoid direct contact with sharp edges or moving parts; interpose a sleeve if necessary.
• Do not over-tighten on fluid pipes or sensitive cables (risk of crushing).
• Store in a dry place, away from UV and excessive heat to preserve elasticity.

Strap with Anchor 140 × 5 mm — the fast, clean, and durable Restagraf fastening solution for organizing your bodywork bundles.

Photo non contractuelle

See all reviews.